(based on 16 reviews)
of respondents would recommend this to a friend.
Reviewed by 16 customers
Displaying reviews 1-10
Back to top
Previous | Next »
from des moines, ia
Comments about Identity Protection Stamp:
Doesn't cover well. Doesn't stamp evenly.
Bottom LineNo, I would not recommend this to a friend
Was this review helpful? Yes / No
- You may also flag this review
About Me Casual Do-It-Yourselfer
I have one hand it should be sent pre-inked as are the stamped address labels
ID Blackout Stamp
from Bronx, NY
Only useful on flat surfaces.
Bottom LineYes, I would recommend this to a friend
I would buy this again
from Costa Mesa, CA
This is the 2nd one I have purchased for a gift...receiver loves it
Identification Guard Blackout Stamper
from Kansas City MO
the stamp face doesn't completely stamp. you have to stamp twice to get everything. Once my ink is gone so is this tool.
(1 of 1 customers found this review helpful)
from Pollock Pines, CA
The blackout stamper is perfect for covering the address labels on magazines. I have literally dozens of mystery magazines that I think others might enjoy but did not want my address exposed. When I tried to pull the label off, the cover ripped. Opaque tape was unreliable and time consuming. The ink pad was easy to load and the stamper easy to use. The pattern on the stamp is a crosshatch that makes the address lettering completely illegible. I can now quickly obliterate my address and donate these magazines.
By M. Hammer
from Pittsburgh, PA
This was perhaps the worst online product I have purchased in years. I am soon returning it, as it broke after using it two times. DO NOT recommend this stamper to anyone.
from Yorktown, VA
Have to stamp over address two or three times for it to work, not sure if it has enough ink, will stick with it [...]
ID Guard Blackout Stamper
from Dallas, TX
About Me Avid Do-It-Yourselfer
Having Arthritis in the hands, it's so easy to just stamp out addresses from mail-ins that need to be discarded. Saves the agony of tearing pages.
works when repaired!!!
from rush point mn
Internal spring was not installed properly. Took half an hour to disassemble and repair.Needs better quality control!!!